Turn the steering wheel all the way in the direction of the burnt out light bulb to give yourself more working room in the wheel well. Try to avoid touching the new halogen bulb with your fingers or anything dirty in the engine bay. Please help support this website by shopping at. Re-insert the socket in to the housing and rotate it counterclockwise to secure it in place. The exact carrier and service used is calculated once the order is packaged for shipment. If you do get the new bulb dirty, wipe it clean a paper towel moistened with rubbing alcohol. Push a new amber colored number bulb straight in to the socket.
Replace the rubber dust cover by pushing it back in to place. If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal. Re-insert the plastic cover in to the wheel well liner and tighten the screw in the clockwise direction until it is snug. Set the dust cap aside in a safe place. Line up the three metal blades on the rear of the new light bulb with the slots on the black plastic electrical connector and push them together. Some of you may prefer to turn the front wheels to the opposite direction.
For shipments to Canada, you can add some items to your cart to determine the shipping rate. Insert the new high beam bulb in to the headlight housing. Push a new number light bulb straight in to the socket. Most in-stock orders will ship out within 24 hours and will reach customers within approximately a week. The low beam headlight bulb is located near the outer edge of the housing.
Reach in behind the headlight assembly and gently pull off the black rubber dust cover. Pull the old light bulb straight out of the socket and push in a new light bulb. The high beam bulb is located near the middle of the headlight housing. Set the dust cap aside in a safe place. Carefully separate the old high beam bulb from the black plastic electrical connector. The side marker bulb is located at the bottom outer edge of the headlight housing.
Set the access cover and the screw aside in a safe place. . Set the plastic cover aside in a safe place. Orders are shipped from Minnesota, ensuring a reasonable shipping time frame to both coasts as well as the areas in-between. Set the cover aside in a safe place.
If you do get it dirty, clean it with some rubbing alcohol. Gently separate the old low beam bulb from the grey plastic holder by pulling it straight off. Most car bulb sockets are removed in the counterclockwise direction. Pull the old bulb straight out of the socket. Reach in behind the assembly and pull off the black rubber dust cap.
Gently lift up the black plastic tab at the bottom of the high beam bulb holder before pulling it straight out of the housing. We use the United States Post Office and FedEx for our shipments. The first two steps are to open the hood and then move to the side of the car with the burnt out headlight bulb. You can also use a brighter bulb. Avoid touching the glass part of the new halogen high beam bulb. Line up the three metal blades on the rear of the new bulb with their corresponding slots on the bulb holder and push them together. For more, check out all of my.
Test the new light bulbs by turning on the headlights, activating the hazard signals and flashing the high beams. We never guarantee a certain method for any order unless it is an express order. In some cases, the order may ship the next business day. We email tracking numbers to customers once orders have shipped, provided a valid email address is on file. Note: I am not a registered charity.
Remove the single screw that holds the access cover in place by turning it counterclockwise with a screwdriver. Replace the rubber dust cap. The front turn signal light bulb is located at the bottom inner corner of the headlight housing. Pull the old turn signal light bulb straight out of the socket. Note - Most car bulb sockets are removed in the counterclockwise direction and secured in the clockwise direction. Donations are not tax deductible.