It said egr valve was bad. I changed wires plugs and coil while i changed each plug and wire i i placed new one to new coil the engien light flashed 10 times b4 i did this and still is flashing 10 times but now it wont even fire start what could be the problem now. Independent shop found issue, a bad computer. Called aaa tow truck driver could not start vehicle. If vehicle sits for some time eventually it will start 3-4 times and then issue will occur again. Did you look at it running at night? Inspected hoses, purge valve for loose connections and cracks.
Had this issue occur before with my wife. If it had not been for the speed bumps in my are hood I would have wrecked for sure. Faulty spark plug or coil boot or 2. I know if my daughter and granddaughters get hurt or worse, I will sue the pants off Chrysler. Put me in a scary situation. Is it safe to drive until tommorrow, when it goes to the dealer for service. I think the pcm must be bad.
I am scared for my family of getting stuck, at least if anything does happen, I will have made this report for others. Took it to autozone and they read the code. I would advise you to make this your first stop before posting a new thread in the forums, as someone may have already asked your question previously and gotten an answer. Very, very dangerous almost got hit 3 times as I made my way over to the shoulder. Original Engine spun bearing at 51000 miles and impecable maintenace. Finally, I would invite you to join the Chrysler Minivan Fan Club Online Showroom. I only have a 30-day warranty because it was purchased used, this is starting to scare me a little and I feel like I made a wrong choice.
I took the van into washington and lee service on Dec. They diagnosed the problem as a fouled ignition coil, and replaced the coil, all the spark plugs and a gasket. The contact stated that the check engine warning light illuminated and the vehicle stalled. The approximate failure mileage was 80,000. Replacement took less than 2 hours and car passed emissions inspection yesterday.
This has happened multiple times since the first occurrence, without injury, or accident. The contact stated that the check engine light illuminated on the instrument panel. I am heading into the dealership now to see what happens. And it's never been in an accident. Garage said problem fixed, but light returned.
It was a large parking lot, so I was accelerating to merge onto us-19 in homossassa springs, fl and the engine stalled completely. You may have to try several different search terms, so please be patient! We have a 2006 Chrysler Town and Country. The manufacturer was notified of the failure. The p2308 code is an error in the ignition coil 3. Cracked vacuum hose at cruise control servo replaced.
I received a call midafternoon that I needed to take the car to a dealer for service, which is when I found out about the service bulletin regarding the engine. In the front of the engine compartment on the passenger's side is the Evap solenoid. Catalytic convertor was replace at owners expense for safety reasons. Take the car to a shop and have them fog the system. I will post back later tonight. The engine started missing then the security indicator light came on and the alarm inside went off.
If you get one misfire it's probably an individual plug wire or plug. Code was for evaporative emissions issue. It is very dangerous and cannot be reproduced to be repaired. That usually means that something went wrong that will damage the emission control system. That same evening, the check engine light came back on, so I returned the van to them.
The van is still running rough any suggestions? P0456 Evap Leak Very Small 2001 - 2011 Caravans and Town and Country The most common cause of this code in this vehicle is easy to fix. We have a 2006 Chrysler Town and Country. There have been a few previous incidents occurring after filling the gas tank sometimes engine sputters, sometimes stalls, and twice the engine revved after restarting after filling the gas tank. Anything I can try to do on my own to solve this? I pulled over turned off the car and let it sit for 5 minutes. Thankfully I didn't and inwas able to slowy make the turn with a lot of effort I needed to at the end of the hill. Suggested resetting light and driving to see if light comes back on.
He said it shows cylinder 1 and 6 misfire. Probably a good bet the computer is bad and should be replaced? A check engine light can indicate a broad spectrum of problems with your 2006 Chrysler Town and Country. He said it shows cylinder 1 and 6 misfire. We have also been told that the brakes need replacing and it only has 47,668 miles on the vehicle. The contact was driving 40 mph when the vehicle stalled followed by the illumination of the check engine warning light.